Don't Forget! ColorPlus® Touch-Up Kit Edge Coater Used to coat exposed edges and nail heads. 16 oz. JH16TU OSI QUADMAX Caulk Hardie® Trim NT3™ Boards E F K A B C D G H I J L Ground to Siding QUICK START INSTALLATION GUIDE HardieInstallation.com Horizontal Flashing Kickout Flashing Roof to Wall Slabs, Path, Steps to Siding Mortar/Masonry Deck to Wall Gutter to Siding Sheltered Areas Blocked Penetrations Drip Edge Flashing Valley/Shingle Extension Butt-Joint Flashing 2” 2” Min. 1/4” clearance. Do NOT caulk. Min. 1/4” clearance. Do NOT caulk. Min. 1/4” clearance Min. 1/4” clearance above flashing. Do NOT caulk. Min. 1/2” clearance Z-Flashing Z-Flashing Z-Flashing Z-Flashing Z-Flashing L-Flashing 2” Kickout flashing 4”x 4” min. 1” 6” USA 8” CANADA Extend shingles at least 1” out from the fascia when gutters are present Joint Flashing Do NOT caulk joint A B C D E G J K L F H I IMPORTANT: This document is not intended to take the place of James Hardie published installation instructions. Failure to install and nish this product in accordance with applicable building codes and James Hardie published instructions may lead to personal injury, affect system performance, violate local building codes, and void the product only warranty. For the latest set of complete installation instructions applicable to your jobsite location, visit HardieInstallation.com or call 1-866-942-7343 (866-9-HARDIE) IMPORTANT FASTENING INFORMATION: James Hardie® siding, trim and soffit products must be installed in a manner that meets local building code and wind load requirements. It is the responsibility of the installer, builder, architect or other building professional and the home or property owner to ensure the fasteners and fastening schedules used result in an installation that is code compliant. Consult ESR 1844 and ESR 2290 or other applicable, local code compliance documentation for guidance on fastener selection and placement to achieve design wind loads for the specific James Hardie siding product, framing type, building height, wind exposure category and other factors relevant to your project. For special circumstances outside the scope of these documents, please refer to the Technical Document library at www.jameshardie.com or contact James Hardie’s Technical Services at 1-888-J-HARDIE (1-888-542-7343). ARCTIC WHITE ONLY ARWH JH10-20 Nominal (Actual) Width 5/4" 4/4" 4" (3-1/2") JH54 JH44 SPECIAL ORDER 5" (4-1/2") JH55 6" (5-1/2") JH56 JH46 8" (7-1/4") JH58 JH48 12" (11-1/4") JH512 Hardie® Trim Tabs Flat and corner tabs for a more aesthetically pleasing installation Corner Tabs 8" Tabs, Box of 50 JH8COTA Flat Tabs Box of 100 JHFLTA TAB SPACING NOTE: Windows and rakes every 12". Corners every 24". ARCTIC WHITE ONLY ARWH JH10-20 Accessories JAMES HARDIE: FIBER CEMENT SIDING ACCESSORIES jameshardie.com 142 ERIEMATERIALS.COM TM Created by Made by Made from the Noun Project SIDING All prices subject to change. Not responsible for typographical errors. See eriematerials.com/updates for major price announcements.
RkJQdWJsaXNoZXIy OTk3MQ==